Click below to download the Gage Makers Tolerance Chart
- Air Gages
- Bore gages
- Calipers
- Calibration Equipment
- CMMs Coordinate Measuring
- CMM Sensors, Probes & Styli
- Computed Tomography – CT Scanners
- Concentricity Gages
- Contour Measurement
- CUSTOM GAGES & FIXTURING
- CYLINDRICAL GO / NO GO / MASTERS
- Data Collection & SPC
- Depth Gages
- Fixtures & Part Holding CMM, Vision, Optical
- Flaw Detection – Automated
- Force & Torque Gages
- Gage Blocks
- Gear & Spine Measurement
- GRANITE SURFACE PLATES, SQUARES & PARRALLELS
- HARDNESS TESTERS
- Height Gages
- HEX, HEXALOBE GAGES & SQUARE GAGES
- ID / OD GAGES & SNAP GAGES
- Indicators & Comparator Stands
- Laser Micrometers
- Layout and Shopfloor
- MICROMETERS
- MICROSCOPES & BORESCOPES
- Optical Comparators, Overlay Charts and Readouts
- Robotics and Automation
- ROUNDNESS & FORM
- SHAFT MEASUREMENT
- Structured Light 3D Analysis
- Surface Roughness Testers
- Thread Gages
- Video Measuring Machines
Blog
British Thread Gages
Posted on by George Chitos
The difference between system A and System B is as follows. System A is plus or minus a turn from notch location vs System B which uses the back face of the gage to check for maximum material.
These gages also come in truncated or full form. The difference being is the truncated crest will allow you to check the pitch diameter but not the radius. The full form allows you to check the radius of the thread.
Thread Gage Design and Thread Gage Designations
Posted on by George Chitos
Click below to download thread gage design information and Thread Gage designations. This applies to Thread Plug Gages and Thread Ring Gages